Rover 12 fuel pump
Posted: Thu Jun 25, 2020 11:17 am
The mechanical fuel pump isnt used on my car a an electric one has been fitted .I want to remove it and fit a blanking plate in it place. However it is impossible to remove the rod,its as thought there is a raised end on the inner part and it just clonks against the engine casing when pulled ,I cant fit a blanking plate as it sticks out a few mm ,so is it OK to cut a few mm off the end, I cannot have it striking a blanking plate The old mechanical pump is quite tatty so I don`t want it left in.
Also since I was unable to find the answer to an earlier question,what is the vertical lever on the photo for ,its connected by cable to a knob on the dash ,the lettering on it is unreadable . Len
Also since I was unable to find the answer to an earlier question,what is the vertical lever on the photo for ,its connected by cable to a knob on the dash ,the lettering on it is unreadable . Len