Front Brakes (Girling Mechanical) - 1936 Rover 12 (6 light)

Re: Front Brakes (Girling Mechanical) - 1936 Rover 12 (6 lig

Postby Frost015 » Mon Jan 21, 2019 10:04 pm

Tony,

As you say, the alignment between pivot arm and entry into expander was not correct, so I ‘corrected’ with rod bends (drivers side only). The main front pivot looks to have been welded at some point in its past, but no packing added .. bit odd, but looks and feels right now. Well spotted on the bolt instead of the pin. .. It came like that, but I don’t think this is right, so to be safe I will substitute with a hardened pin before it goes on the road.

Thanks for info on Frosts Paints, I was planning on getting their chassis paint, will look at your reference. Incidentally, do you know the nearest colour for the engine block (also from Frosts ?) .. I would like to repaint it factory green (badly overpainted black at present).

Lots to do !

Will be in touch if and when a trip to Colchester area is on the horizon..

Ian
1936 Rover 12 Saloon
Frost015
 
Posts: 8
Joined: Wed Oct 10, 2018 2:48 pm
Location: Stamford (Lincs)

Re: Front Brakes (Girling Mechanical) - 1936 Rover 12 (6 lig

Postby TonyG » Tue Jan 22, 2019 1:16 pm

Hi Ian,

There has been a lot of debate in the past regarding the original engine colour.

There has been considerable opinion but the most likely, in my view, is that the colour varied depending on whatever paint was kicking about in the factory at the time. This might explain why some cars have dark green engines, mid green, light green, pale blue, red and black.

The challenge once a colour is chosen is to find a supplier of quality heat and oil resistant paint. At that point the choice of colour becomes more limited and a compromise is required.

It’s quite a fiddle stripping the engine ancillaries to paint it and not something you want to do very often. I did my Tourer in a shade of mid green quite like the original but the paint isn’t great quality and will need doing again. Hence, when I did my P2 engine I opted for Frost Buick Green engine enamel, which I suspect will last much better. It’s a bit lighter in colour but looks great on the installed engine.

I’ve sent you an email via the RSR site. If you would like to contact me by return I can send you a picture of the engine to demonstrate the colour.

Tony.
Tony Gilbert

P1 12 Tourer
P2 12 6 Light Saloon
Discovery 3
Discovery Sport
TonyG
 
Posts: 46
Joined: Mon Sep 07, 2015 3:38 pm

Re: Front Brakes (Girling Mechanical) - 1936 Rover 12 (6 lig

Postby luli » Tue Jan 22, 2019 5:05 pm

In my 1947 tourer the longitudinal rod is bent, and the transversals are straight. In the 1946 10 all rods are straight. See some pictures here https://wp.me/pXLKy-3EU
Rover 10 1946 RHD
Rover 10 1947 LHD
Rover 12 1947 tourer LHD
http://lulisml.wordpress.com/
User avatar
luli
 
Posts: 346
Joined: Sat Jun 04, 2011 5:49 am

Previous

Return to Wilks' cars P1 and P2, thats cars up to 1947

Who is online

Users browsing this forum: No registered users and 0 guests

cron