Rover Sports Register Forum

Thanks for that Phil

Does Mike stock them as remanufactured or were they a pair he had lying about, and what sort of price are they if you don't mind me asking

Mike

Thanks for the help Luli I can now see how it is put together I like the varnish trick to make the knob like new again

Mike

Yes I've taken to using it all the time, living in the lakes with all the hills is probably exciting I bet,

I have a nicer chromed handle that I would like to install at some point but cannot see how the cable is threaded into the handle yet any ideas

Mike

After working on my 39 P2 over the winter and tuning her up, I am now going to go to some rallies, starting with the fathers day rally at Harewood house, now I live in Nottinghamshire so its a little treck to get there, I also went there last year, so fuel costs can be quite high in a vehicle that d...

HI

My P 2 has wooden running boards fitted which although are a decent job I would like to see if I could have some steel ones made, My question is;
does any body have the Dimensions or a drawing of a 39 P2 running board ?

Any help would be appreciated

Thanks

Mike

Hi there
I am looking to replace my radiator cap on my 39 p2 with a flat top one so I can mount a mascot on it does anyone know what is available out there as a spare or have the the information what to look for ?
Any help would be appreciated
Thanks Mike

Hi There The alternator I purchased was not the correct model for my car, so my mistake, it was exchanged without any problems, have now fitted the new one, problems solved with the charging issues now,I have disconnected the wiring associated with the voltage regulator and left it in place as per t...

Hi there I purchased a Dynametor and have started to fit it this weekend, my original one on the car was a C45 so the new Dynametor will fit using the existing brackets which is good, however when removing the pulley off the old unit it is not a match for the new unit, old unit shaft diameter is 17m...

Thanks for the reply, do you think I will need to make up a bracket for the p2 to make it fit ?

Hi
Just another note, when adjusting valve clearances hot or cold use the rule of nine IE when no 1 exahust valve is open you adjust exhaust valve number eight

And the same for the rest, two open adjust seven etc.

Mike