P2 Brakes

[TonyG]

Hi Adrian,

I don’t think there should be any ‘free play’ with regard to the operation of front/rear brakes. Mine are set so that they all operate at the same time, as is the case with hydraulic brakes. In fact, I’m pretty sure that the arm where the rod to the front and the other to the back are connected acts as a compensator meaning that they have to engage at the same time but I’d have to get under my car to be certain. The pedal height adjustment is not, to my knowledge, a facility to adjust the brakes; with the clutch cable correctly adjusted with just a little free movement before operation, the pedal height can be positioned at an appropriate height to allow comfortable operation. The brake pedal should have minimal free movement before they operate if the brakes are correctly adjusted, so the pedal height can then be set to match the clutch pedal.

Hope that helps.

Tony

[luli]

The rod brakes system is designed for the leaf springs and the rigid axles. The distance between the axles changes with the load on the car. The purpose of the telescopic segment is to make this distance increase without applying the brakes or decrease without distorting the rods. Therefor some distance must be kept between the two halves of main rod, resulting in some free travel of the brake pedal, This distance should be adjusted so that the free travel of the pedal would be ~1”.
Also, on non flat surface, one wheel will be higher than the other, resulting in an angle between the chasis and the axle. This why the rear compensator is mounted on a pin and can turn as necessary. The front compensator has a similar arrangement.

dsc_2766.jpg (37.96 KiB) Viewed 334 times

dsc_2765.jpg (28.37 KiB) Viewed 334 times