1936 - Opening front windscreen - aluminium base
Posted: Sun Nov 08, 2020 9:55 am
Time to get the windscreen back in .. however a couple of questions on the aluminium section that screws first onto the car ..
https://www.rover-forum.thersr.co.uk/do ... iew&id=206
1. I plan to bed this down into soft bitumen sealing compound .. good idea or not ?
2. It came out as bare aluminium ... although this could have been stripped by previous owner. Before installing I plan to etch coat and then spray in a neutral silver colour. Is this correct ?. Or should I leave unpainted, or go body colour ?
https://www.rover-forum.thersr.co.uk/do ... iew&id=205
Thanks for any responses ..
Ian
https://www.rover-forum.thersr.co.uk/do ... iew&id=206
1. I plan to bed this down into soft bitumen sealing compound .. good idea or not ?
2. It came out as bare aluminium ... although this could have been stripped by previous owner. Before installing I plan to etch coat and then spray in a neutral silver colour. Is this correct ?. Or should I leave unpainted, or go body colour ?
https://www.rover-forum.thersr.co.uk/do ... iew&id=205
Thanks for any responses ..
Ian