Rover Sports Register Forum

Hi
I looking for a dimension drawing/blueprint of a P2 (12) chassis. I'm looking to build a special and would like to compare it to other similar chassis's.
Any help greatly appreciated.
Thanks

Try the RSR they should have information, the RSR workshop Manual and Parts list is helpfull but does not give dimensions.

See the attached for a general view



The following is from James Taylor's book:-

wheelbase 105 inches 1934-1936, 112 inches 1937-1947 and all 6 light saloons 1935-1947. Front track 50 inches, rear track 51.5 inches (34-39) 54 inches (40-47. Length 156 inches - (34-36 sports saloons), 160 inches 35-36 saloons, 161inches (34-36 tourer), 169.5inches (37-47). Width 62inches (37-47), height 63 inches (37-47 saloon), 61 inches (37-47 sports saloon). Ground clearance 6.5 inches, (5.5 inches 34-36 sports saloon)

Hope this helps

Regards

Mike Maher

Thanks chaps for the information. I've got the drawing you've posted Mike. I've began modelling on CAD the 12 chassis I've already got. It's just to give me some help/guidance on the special I'm attempting to build.

Thanks
Simon

Hello Simon,

Sounds like it will be a fun project I hope you will share photos with the forum of your progress.

Good Rovering
Dirk in the states

I am about to embark on a conversion of a 1935 10 saloon to a tourer, if your ' special ' is a similar conversion could we compare notes ? I shall write up for Freewheel . Thanks Chris