Jacks supplied with Rover cars.

Interesting facts and anecdotes about the company itself
Post Reply
Dkenner
Posts: 24
Joined: Mon Oct 31, 2016 9:13 pm

Jacks supplied with Rover cars.

Post by Dkenner » Wed Jan 23, 2019 6:15 pm

Gentlemen,

I am writing up an article for our club newsletter on the jacks supplied with the Series Land-Rovers. Generally Shelley, I thought it would be interesting to see if they were common with the early Land-Rovers, and if not, to make reference to what was supplied with the Rover P2 to P4 or 5 cars. Searching the forum, there does not seem to be any discussion on the original equipment (air pump, jack, tool roll, etc) supplied with these vehicles. Would anyone have a reference to what was supplied?

Thank you,

Dixon
Dixon Kenner
1950, 51, 52 Land-Rover, 1976 101FC

GOY189
Posts: 571
Joined: Sun Oct 19, 2008 5:08 pm

Re: Jacks supplied with Rover cars.

Post by GOY189 » Sat Jan 26, 2019 9:40 pm

Which club newsletter are you writing for? The spanners, pliers, screwdriver and small tools were in a tray not a tool roll. The P2/3 car jacks were smiths /stevenson pillar jack or bevelift. Hatches in the wooden floor of the car near the front seats gave access to jacking points in a chassis cross member. Inserting the lifting arm and raising the jack, lifted the driver or passenger side of the car. P4s and P5s used a smiths "A" frame jack and below sill jacking points.

Hope this helps

Dkenner
Posts: 24
Joined: Mon Oct 31, 2016 9:13 pm

Re: Jacks supplied with Rover cars.

Post by Dkenner » Sat Feb 23, 2019 5:23 pm

Article is for the Ottawa Valley Land-Rovers club in Ottawa Canada.

https://www.ovlr.org/nl/OVLR.nl.freq.html

I am currently the editor and always am looking for, or generating, material.
Dixon Kenner
1950, 51, 52 Land-Rover, 1976 101FC

Post Reply