Thanks,
How get it INTO the mesh?
If I just pour/dribble it into the mesh holes, will that be enough?
How can I try to get it into ALL of the mesh
Air Filter: what paint finish would be correct
Re: Air Filter: what paint finish would be correct
Another Question:
The canister has a hole at the end (see pic). If it was a removable top - then it would presumably have a screw/bolt in it.
But my canister is a 'sealed' type.
Should I leave it 'as is'
Or cap it with something?
The canister has a hole at the end (see pic). If it was a removable top - then it would presumably have a screw/bolt in it.
But my canister is a 'sealed' type.
Should I leave it 'as is'
Or cap it with something?
- airFilterEnd.jpg (23.02 KiB) Viewed 688 times